| Technical information | |
|---|---|
|
Application method |
Dispense system, Manual
|
|
Applications |
Bonding close fitting parts, Repairing |
|
Fixture time, Steel |
5.0 sec.
|
|
Key characteristics |
General purpose, Strength: high strength, Viscosity: low viscosity, fixture: very fast fixture
|
|
Operating temperature |
-40.0 – 120.0 °C (-40.0 – 250.0 °F )
|
|
Viscosity |
100.0 mPa·s (cP)
|
|
Recommended for use with |
Elastomer, Metal, Plastic, Porous surface
|
It is recommended to use LOCTITE® SF 7063/7064 to degrease and clean surfaces prior to applying the adhesive.
To improve adhesion on difficult to bond plastic surfaces, apply LOCTITE® SF 7239 or LOCTITE® SF 770 to the bond area by brushing or dipping. Avoid applying excess primer. Allow the primer to dry.
If cure speed is too slow, use appropriate activator LOCTITE® SF 7458 or LOCTITE® SF 7455 (see cure speed vs activator graph in TDS). Apply activator to one bond surface by spray, brush or dipping (not primed surfaces). Allow the activator to dry.
Apply adhesive onto one side/part.
Assemble parts immediately. The parts should be accurately located as the short fixture time leaves little opportunity for adjustment. Bond should be held or clamped until the adhesive has fixtured. Hint: if necessary, excess product can be cured by activator LOCTITE® SF 7458 or LOCTITE® SF 7455. Spray or drop activator onto excess product.
Too See AeroShell Fluid 41 technical data sheet (TDS) and the AeroShell Fluid 41 safety data sheet (SDS). Visit here
